Hotpoint ETPI 5620 IN Návod k použití Strana 7

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 7
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 6
17
Declaration of
conformity
This cooktop is suitable for
contact with foodstuffs, and
complies with EEC Directive
89/109.
These appliances are
designed solely for use as
cooking appliances.
Any other use (such as
heating rooms) is to be
considered improper and, as
a consequence, dangerous.
The appliances are designed,
built and sold in compliance
with:
- safety requirements of
EEC Directive Low voltage
73/23;
- protection requirements of
EEC ECM Directive 89/336;
- requirements of EEC Directive
93/68.
Electrical connection
To be done before connection
to the electricity supply.
The appliance must be
installed by a qualified
technician who is fully aware
of current safety and
installation regulations and
who will comply with these
regulations.
Make sure that the voltage
indicated on the rating plate
corresponds to the voltage in
your home.
Regulations require that the
appliance is earthed; for this
reason all conductors and
earth conductor must be of
the appropriate size.
Make sure the earth
connection is made correctly.
The manufacturer declines all
liability for injury to persons
and animals or damage to
property resulting from failure
to observe the above
regulations.
For the electrical connection
use the HO5RR-F type cable
supplied as indicated in the
table below:
An all-pole disconnect
switch with minimum
contact gap equal to or
greater than 3 mm must be
used to install the hob.
Attention: the power supply
cable must be long enough to
allow the hob to be removed
from the worktop and must be
positioned so as to avoid
damage or overheating
caused by contact with the
base.
Terminal block connections
Note: The earth wire (yellow/
green) must be connected to
the terminal with the symbol
and must be longer than the
other wires.
-Connect the wires to the
terminal block as indicated in
the diagram printed on the
bottom of the hob.
-Secure the power supply
cable (B) by means of the cable
clamp. Close the box lid (A).
After the initial electrical
connection or whenever
turning the hob on/off, a
symbol, (for example E-00,
E-01, E-02) will be displayed
for a few seconds.
Power
supply
voltage
Conductors
(number and size)
220-240 V
3 X 2.5 mm
2
min
4gb66015a.fm Page 17 Friday, February 6, 2004 12:16 PM
Zobrazit stránku 6
1 2 3 4 5 6 7

Komentáře k této Příručce

Žádné komentáře