Hotpoint GQ64ST Uživatelský manuál

Instructions for Installation and UseGas HobsModel GQ74STModel GQ74SIModel GQ64STModel GQ64SI

10Electrical ConnectionElectrical connectionWARNING: THIS APPLIANCE MUST BE EARTHED.The hob is designed to work with alternating current, thesupply vo

11Characteristic of the burners and nozzlesTable 1 Liquid Gas Natural GasBurner Diameter(mm)Thermal PowerkW (p.c.s.*)By-pass1/100(mm)Nozzle1/100Flow*g

12

13

GB14"No company is better positioned to offer an after sales service on aHotpoint appliance than us - the manufacturer"As part of our commit

GB15Guarantee"Satisfaction guaranteed or your money back"We give you a unique 'satisfaction guaranteed' promise - valid for 90 day

11/2004 Part no. FP159 - 01Over 1200 trained specialists, directly employed by us, ensure that you can have complete confidence inboth the appliances

2CONTENTSIntroductionFor Your SafetyKnow your HobHow to use your HobPractical AdviceCare and CleaningTroubleshootingInstallationElectrical ConnectionC

3Your new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has beeninstalled in accordance with t

4For Your SafetyALWAYS:- make sure you remove all packaging and dispose ofsafely.- check the soundness of the appliance after it has beenunpacked.- ma

5B. Gas BurnersE. Control KnobsA Auxilliary burnerR Rapid burnerS Semi Rapid burnerHow To Use Your HobKnow your HobThe position of the corresponding g

6Care and CleaningBefore cleaning or performing maintenance on yourappliance, disconnect it from the electrical power supply.To extend the life of the

7InstallationThe following instructions are intended for the installer so thatthe installation and maintenance procedures may be followed inthe most p

8560 mm.45 mm.When installing the hob above a built-in oven without forcedventilation, ensure that there are air inlets and outlets for ventilatingthe

9Check the SealOnce the hob has been installed, make sure all the connectionsare properly sealed, using a soapy water solution. Never use aflame.Adapt