Hotpoint TDC 75 Návod k použití stáhnout pdf (Strana 2)

SAFETY ADVICES BEFORE USING THE

DRYER / CONNECTIONS

1. Removing the packaging and check

•

After unpacking, make sure that the dryer is

undamaged. If in doubt, do not use the dryer.

Please contact 0870 5425425.

•

Keep the packaging materials (plastic bags,

polystyrene parts, etc.) out of reach of children, as

they are potentially dangerous.

•

Remove the protective foil from the control panel.

2. Electrical Connections

•

Electrical connections must be carried out by a

qualified technician in compliance with the

manufacturer's instructions and current standard

safety regulations.

•

Electrical connection must comply with local

Electricity Board regulations.

•

Voltage information, power consumption and the

required fuse protection is shown on the rating

plate mounted at the rear of the dryer.

•

The manufacturer cannot accept any liability for

personal injury or damage to property resulting

from failure to adhere to these instructions.

•

The dryer must be earthed as prescribed by law.

•

Do not use extension leads or multiple adaptors.

•

Before any maintenance on the dryer disconnect it

from the mains supply.

•

Do not operate the dryer if it has been damaged

during transport. Please contact 0870 5425425.

•

Mains cable replacement is only to be carried out by

qualified technician or competent person.

•

After installation access to the mains plug has to be

guaranteed, or the all-pole disconnection has to be

possible with a switch.

3. Installation

•

Do not install your dryer where it can be subject to

extreme conditions, such as: poor ventilation,

temperatures around freezing or above 35° C.

•

Before running the first cycle ensure the water

container and heat exchanger are correctly

positioned.

•

Take care not to install the dryer on a deep-pile

carpet.

•

Take care not to trap the mains cable between the

dryer and the wall.

Stability:

When installing the dryer always carefully level the

dryer adjusting the four feet and check the correct

levelling with a spirit level.

Minimum housing dimensions:

Width: 600 mm

Height: 855 mm

Depth: 600 mm

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře

Hotpoint TDC 75 Návod k použití Strana 2

Komentáře k této Příručce

Související produkty a manuály pro ne Hotpoint TDC 75