Hotpoint HJA1703 Návod k použití stáhnout pdf (Strana 5)

Installation instructions

Installation

Preparing the housing unit

• Cut the worktop to fit before installing the

appliance. Carefully remove any shavings or

sawdust that could prevent the appliance from

running properly.

• The hob must be fitted in a worktop with a

minimum thickness of 20 mm and a maximum of

50 mm.

• Insert a separator panel at a minimum distance of

90 mm from the bottom of the hob, so that it

cannot be accessed by the user.

• If there is an oven under the hob, make sure that it

is manufactured by us and equipped with a

cooling system.

• There must be nothing between the hob and the

oven (e.g. cables, insulating material, etc.).

• An adjacent column unit must be installed at least

100 mm from the edge of the hob.

• Cut an opening in the worktop of the given

dimensions.

• We recommend you seal the internal edges of the

worktop with wood glue or silicone.

• If not already in place, apply the supplied seal to

the hob, after cleaning the adhesive surface

thoroughly.

Glass-ceramic hob

Make sure that the opening in the worktop for the

hob is cut according to the dimensions given in the

drawing, paying attention to the tolerance range.

The hob should not be forced into the worktop.

Forcing the glass-ceramic top may cause a crack

(even later)!

• If the worktop is made of wood, use the spring

clips and screws provided.

1. Secure the spring clips (A) (fig. 1) with the

screws provided (B) (fig. 1) as shown, paying

attention to the specified distances.

2. Fit the hob into the worktop.

• If the worktop is made of marble, plastic,

ceramic, stone, etc., the hob must be secured

with special brackets (C) (fig. 2).

1. Fit the hob into the worktop (fig. 1).

2. Place the 4 brackets (C) in position in

accordance with the thickness of the worktop

as shown in fig. 2.

3. Fasten the 4 screws (D) in the positions (E)

(fig. 2).

WARNING

To install the hob on other

surfaces than wood (plastic,

ceramic, marble, stone, etc.)

remember to ask After Sales

Service for the fixing plates (fig. 2)

Code 4819 404 78697.

WARNING

Remove any protective film before

installing the hob.

Fig. 1

Fig. 2

Fig. 3

1 2 3 4 5 6 7 8 9 10 11

Komentáře k této Příručce

Žádné komentáře

Hotpoint HJA1703 Návod k použití Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Hotpoint HJA1703